5
REAR PANEL FEATURES
1.
VOLTAGE SELECTOR ---
Set this switch to the voltage
for your location.
2.
POWER PLUG CONNECTOR
–
Plug your supplied
power cord in here.
3.
POWER SWITCH
–
Turn the machine on and off with
this button. The unit should always be shut down with
this button first before any external power is removed.
Typically it is recommended that the CD player is
powered on before amplifiers and powered off after
amplifiers.
4.
RCA AUDIO CONNECTORS
–
Connect your CD
player to your mixer from this line level output.
5.
REMOTE START CONNECTOR –
To use this connector for fader start, connect a fader start cable (not included) to a
fader start-compatible mixer. Every time you move the crossfader on the mixer over to the side that the unit is on, it will
automatically start playing. When you move the fader away from that side, the unit will stop. Moving the fader back to
the unit side will start play again.
LCD FEATURES
1.
PLAY / PAUSE –
This shows when
the unit is playing or paused.
2.
CUE –
Flashing when the unit is
setting a cue point. Lit continuously
when the unit is paused at a cue
point.
3.
TRACK NUMBER –
Shows the
current track number.
4.
MINUTES –
Shows the minutes
elapsed or remaining depending on
mode setting.
5.
SECONDS –
Shows the seconds
elapsed or remaining depending on mode setting.
6.
FRAMES –
The CD player breaks down a second into 75 frames for accurate cueing. This shows the frames elapsed or
remaining depending on mode setting.
7.
SEARCH –
When engaged, search mode will allow you to use the jog wheel to quickly scan through the current track.
8.
TIME MODE –
Indicates whether the time shown on the LCD is the elapsed time for the track, remaining time for the
track, or total remaining time for the entire CD.
9.
TIME BAR –
Shows either time remaining or elapsed depending on the setting of the TIME button.
10.
PROGRAM –
Indicates that a program is playing.
11.
SINGLE –
Shows when the unit is set to play just one track at a time (Single Play Mode). This function is controlled by
the SINGLE button.
12.
CONTINUOUS –
Shows when the unit is set to play tracks continuously, without stopping (Continuous Play Mode). This
function is controlled by the SINGLE button.
13.
LOOP –
Indicates when a loop is programmed. When the indicator is flashing, a loop is currently playing. When "IN /
OUT" is shown, a loop is programmed but not currently playing.
14.
PITCH –
Shows the percentage change in pitch.
1
2
3
4
5
