7
ASSEMBLY INSTRUCTIONS
9) Insert the top piece of the
canopy frame bars
(F) into the "U" bracket on the
canopy frame
center piece (C). Line up the holes and insert an
M4 x 20 L bolt (AA). Fasten with an M4 nut (FF)
using an M4 hex wrench and Phillips head
screwdriver to tighten the
M4 x 20 L bolts (AA).
Do not overtighten! See Figure 9.
Figure 9
FF
AA
C
F
Hardware Used
Part Description
Quantity Picture
AA
M4 x 20 L bolt
4
FF
M4 nut
4
10) Place the
wind vent canopy (H) over the top of
the
canopy frame bar (F). Slip the poles into
each corner pocket of the
wind vent canopy (H),
completely covering the canopy bars. See
Figure 10.
Figure 10
H
H
F
F
11) Place the fully assembled canopy on the top of
the assembled panel posts. Line up the holes on
each of the
short connect bars (G) with the
holes on the
"L" connect brackets (HH).
Insert an
M6 x 40 L bolt (CC) and M6 metal
washer (EE), through the "L" connect bracket
(HH), and the
short connect bars (G), and then
add one more
M6 metal washer (EE). Fasten
with an
M6 nut (GG) using the provided
wrenches to tighten the
M6 x 40 L bolts (CC).
IMPORTANT! Do not tighten completely!
Repeat this procedure for the three remaining
corners.
Use the provided wrenches to securely tighten all
of the
M6 x 40 L bolts (CC). Do not
overtighten!
Place an
M6 nut cap (KK) over each M6 nut
(GG). Place an
M6 bolt cap (LL) over each M6
x 40 L bolt (CC). See Figure 11.
Figure 11
G
I
KK
GG
G
EE
EE
I
CC
LL
HH
Hardware Used
Part Description
Quantity Picture
CC
M6 x 40 L bolt
4
EE
M6 metal washer
8
GG
M6 nut
4
LL
M6 bolt cap
4
KK
M6 nut cap
4
