CDN-32S
- The Leader in DJ Technology
©1999 Numark Industries
- 7 -
http://www.numark.com
CONNECTIONS
Typical connection with a mixer is illustrated right.
1.
Connect the output connection cords from the CD Player to the line
inputs of your mixer.
2.
Connect the remote control connection cable from the Unit 1 connector
on the main unit to the Unit 1 connector on the remote control unit.
Repeat for Unit 2.
3.
The output connection cords and the remote control connection cables
are supplied with the main unit. Be sure to use the remote control
connection cables which have been supplied. Use of another cable type
might cause damage.
4.
Connect Relay or Fader start cables
•
For fader start attach both side of your CD play to a similarly equipped
DJ mixer, as in the top drawing.
•
For relay capability take the autostart cable and connect the two jacks in
the rear of your CD player.
POWER ATTACHMENT: Your CD player is
equipped with an IEC style power connector.
Please first select the proper voltage for your
location. Next, plug in you supplied power
cable into the rear of the unit then plug into
the appropriate power outlet.
DIGITAL OUTPUTS: This CD player is specially equipped with digital outputs. The format is
type 2, form 1, also known as S/PDIF (Sony/Phillips Digital Interface Format). In order to use
the digital output you must activate the rear panel switch. When the digital output is active
the variable pitch slider and pitch bend buttons or pitch wheel will not work.
Note: If digital information was allowed to change in pitch, other devices will not read the digital output properly.
MOUNTING YOUR CD PLAYER
•
Mount the units in your console or rack with 19” EIA rails
•
The transport should be mounted not to exceed an angle of 15 degrees.
•
Your CD player can be affected by excess vibration so mount the units
in a secure environment if possible.
