Light switch has been placed either on control panel or next to controller.
Door Lock
Is fitted on side of door.
Remove plastic film on stainless steel, roll out stretchers, clean interior and exterior of cabinet. If
necessary with warm water and detergent.
Our mortuary refrigerators / freezers can be either with built in motor or remote (motor is placed
externally of building or in a plant room).
Electrical Connection.
1.
Check label on cabinet before connecting to power supply, to confirm if it operates on 240v
50Hz or 3 phase.
2.
The wall socket should be easily accessible.
3.
All earthing requirements stipulated by your local authority.
Start-up of cabinet.
If cabinet has been fitted with a 3 pin socket then you can plug unto the appropriate wall socket.
Once power is switched on there is up to a 60 second delay prior to compressor starting up.
Cabinet temperature has already been set unless specified, it has been programmed to operate
between 2 and 5
℃
, however this can be adjusted refer to dixel controller instructions located at the
back of manual if required.
NRMF Range -20
℃
freezer
Please follow the previous steps however your temperature control has been programmed to
operate at -22 - -18
℃
with defrost periods every 6 hours for self-contained or remote version.
Cabinet temperature will slowly start to drop, it could take up to 30 minutes prior to reaching
desired temperature, if this has not been achieved then contact your local distributor and turn
power of at power supply.
Preventative maintenance