NUK Eco Control Audio 500, Руководство по эксплуатации

Страница: 31 / 122

29
6.4 Adjusting the volume
control
1. You can use the VOL + 10 and VOL - 11
buttons to set the volume at which you
hear the sounds emitted by the parent unit.
Each time you press one of the buttons you
will hear a beep at the volume that is
currently set up and it will show you with
the accordance of lit LEDs
16 . The louder
your chosen setting, the louder any beeps
will be and the more LEDs will light up.
Note: When the VOX function is set to
low sensitivity (see "6.3 Using the VOX
function to adjust the transmission
sensitivity" on page
28), then quiet
sounds will not be transmitted regardless
of the volume setting. This means that
turning up the volume will not enable you
to hear anything more. If you want to hear
more of the sounds from the nursery you
will need to increase the transmission
sensitivity by selecting a higher VOX
level.
6.5 Mute setting
The parent unit can be “MUTED”. Sounds
from the nursery will then no longer be
transmitted.
1. Press the
VOL - 11 button repeatedly
until you can no longer hear beeping.
No sounds will now be transmitted.
2. The LEDs 16 will continue to indicate the
noise level in the nursery. The more LEDs
are lit the louder are the noises in the
nursery.
3. You can cancel the mute setting by
pressing the VOL + 10 key.
4. If the parent unit is muted and you
activate the Talk-Back function, the
volume will automatically return to the
first level.
6.6 Talk-Back function
You can use the “Talk-Back” function to
speak to your baby.
1. Hold down the
TALK 18 button on the
parent unit.
When you hear a beep, this means that
voice connection is established.
2. At the same time, speak into the
microphone 20 on the parent unit.
Your baby can now hear your voice from
the loudspeaker
2 on the baby unit.
3. Release the TALK 18 button in order to
hear the baby’s reaction.
Notes:
– If the baby unit 1 is in Eco-Mode, this
function is deactivated so that you do
not inadvertently wake your baby. In
this case, two consecutive beeps will
remind you that the Talk-Back function
is currently not available.
– If the volume of the parent unit is set to
“MUTE” (see "6.4 Adjusting the volume
control" on page
29), it will
automatically be increased to level 1 as
soon as you press the
TALK 18 button.
7. Cleaning and care
7.1 Cleaning
Warning! To avoid the risk of electric
shocks, injuries and damage:
– Always disconnect the mains
adapter from the power socket
before cleaning the device.
– Never immerse the individual
parts in water.
Caution! Under no circumstances use
abrasive, corrosive or scratching cleaning
agents, as these could damage the device.
1. If necessary, wipe the individual parts
with a damp cloth.
2. Only use the baby monitor again when all
the parts have fully dried out.