Nuheat Freeze Protection Products
toll free 1.800.778.WARM (9276)
fax 604.529.4404
www.nuheat.com
[email protected]
Nuheat™
is the registered Trademark of Nuheat Industries Ltd.
Printed in Canada
April 2013
HOW TO CREATE AN END SEAL
1. Strip and remove outer jacket ½" from the end. Cut
off exposed ground braid. Do not cut into inner jacket.
2. Place the heat shrink cap over the end of the cable as
far as it can go.
3. Hold the cable vertical with the cap upwards. Using
heat gun, shrink the cap onto the cable.
4. Wrap the entire cap including the 4" long aluminum tape.
Repeat if necessary to find the best lay angle to ensure
entire heat shrink cap is covered. Smooth tape with
fingers to ensure no sharp edges.
5. Slide heat shrink tube to cover the cap. Line end of heat
shrink tube with top of heat shrink cap. Shrink tube. Hold
for 15 seconds.
3
/
4"
3
/
4"
3"
3"
3
/
4"
3
/
4"
3
/
8"
3½"
3½"
