Receiver: nuPro X active loudspeaker
Transmitter: nuPro X active loudspeaker
In this classic configuration (please refer to the nuPro X loudspeaker
owner’s manual for details), all settings are adjusted on the Master speaker.
No changes can be made to the settings of the Slave speaker,
including channel selection and volume.
Receiver: nuPro X active loudspeakers
Transmitter: XS-7500 or nuConnect ampX
nuPro x loudspeakers in Slave mode/
wls slave
have no configuration options.
• However, before configuring the nuPro X speaker as the Slave/
wls slave
,
you can select the correct channel (left, right, or mono), as the nuPro XS-7500
does not transmit channel configuration information.
• The relative level of the slave speaker(s) can be set in the
zone ctrl
sub-menu
on the XS-7500 or nuConnect. For more details, please see the
zone ctrl
section
in the owner’s manual on page 11.
• The overall level of the Slave-speakers is set on the Master (transmitting) system.
Receiver: nuPro XS-7500 or nuConnect ampX
The nuPro XS-7500 and the nuConnect ampX remain fully operable when set
as Slaves/
wls slave
.
• The received audio signal is sent to the wireless (wls) input which can then
be selected like any other input.
• Output level on the slave device is set independently from
the master device.
Receiver: nuSub XW
Nubert XW-generation Subwoofers are preconfigured as Slaves/
wls slave
,
this setting cannot be changed.
• The subwoofer is sent an unfiltered, full-range signal.
• The crossover frequency of the subwoofer as well as its relative level
must be set on the subwoofer itself. The overall level of the subwoofer
and main speakers is set on the main system.
Nubert electronic GmbH · Goethestr. 69 · D-73525 Schwäbisch Gmünd · www.nubert.de · [email protected] · Hotline: +49 7171 92690 118, Deutschland 0800-6823780
®
nuPro XS-7500 · Quick Start Guide · 11/2019
4
5
Wireless audio transmission in the Nubert Wireless System
Any X-platform-based devices can exchange audio- and control-information with each other. The
nuPro X active speakers
, the
nuSub XW
and
the
nuConnect ampX
all belong to this family. The device transmitting the signal is the Master, the device receiving the signal is the Slave. On
some devices, this setting is fixed, others, like the nuPro XS-7500, are freely configurable. For more details, please see the
setup
section in the
owner’s manual, on page 11.
Please observe the following, depending on which type of device is used as the receiver:
