MAINTENANCE
NU–VU® equipment is designed to last for years of useful service. Careful consideration is given in selecting
components for durability, performance and ease of maintenance. For example, both the Oven Motor and Proofer
Motor have sealed bearings and never need to be lubricated.
While NU–VU® equipment is designed for minimum care and maintenance certain steps are required by the user
for maximum life and effectiveness:
•
Proper installation of the equipment.
•
Correct application and usage of the equipment.
•
Dry–Out Procedures performed daily.
•
Thorough cleaning on a regular basis.
STANDARD PROOFER DRY–OUT PROCEDURE:
A.
Remove the Water Pan. Empty and clean the Water Pan and set it aside.
B.
Wipe up any standing water in the bottom of the Proofer.
C.
Turn the Proofer Power Switch
ON
. Leave the Temperature Control and Humidity Control at their nor-
mal settings.
D.
Leave the Proofer Door open about 1" to 2" and allow the Proofer to run for about 30 minutes.
E.
Turn the Proofer Power Switch
OFF
. Leave the Proofer Door open by about 1" to 2" while the Proofer is
not in use.
AUTO–MIST PROOFER DRY–OUT PROCEDURE:
A.
Wipe up any standing water in the bottom of the Proofer. You may need to remove the Element Cover
to do this.
B.
Turn the Proofer Power Switch
ON
. Leave the Temperature Control at its normal setting but turn the Hu-
midity Control to
OFF
.
NOTE: You may also need to turn off the water supply.
C.
Leave the Proofer Door open about 1" to 2" and allow the Proofer to run for about 30 minutes.
D.
Turn the Proofer Power Switch
OFF
. Leave the Proofer Door open by about 1" to 2" while the Proofer is
not in use.
OVEN DRY–OUT PROCEDURE:
A.
Set the Oven Temperature Control and Oven Power Switch to
OFF
.
B.
Leave the Oven Door open about 1" to 2". The residual baking heat will dry out any moisture that may
be trapped in the insulation or other components of the Oven.
C.
Leave the Oven Door open by about 1" to 2" while the Oven is not in use.
Содержание UB-5
Страница 1: ...UB 5 10 MAINTENANCE CLEANING GUIDE...