User guide DX32R
Doc no. DX32R-8001-A-4
Rev. date 201203
Page 6 of 10
The selection of either of the two recovery modes are fixed after selection. The purpose of the recovery
mode is to download new firmware to the unit running only the fixed internal boot code in a simple default
configuration if download of firmware is not working in normal operating mode of the unit. By enabling
recovery mode with default IP address and network configuration the unit can always be identified on a
network via the default setup. Once download is completed the unit will enter normal operation. Alternatively
the unit has to be re-powered.
Note that the IP address referred to is the IP address of the controller/management interface of the
unit. This is not the IP address of the IP audio interface if a such is installed. This IP address can not
be managed locally on the unit.
Restore defaults
“reconfig
”
long push 10 sec.
while the unit is in
normal operation.
Release
reconfig
”
button
Green LED
OFF
The DX32R enters a restore default mode. In this
mode all setting of the unit is initialized to the
factory programmed defaults.
The IP address of the unit is the one currently
used and stored in the internal EERPOM
When the
“reconfig
” button is released the
firmware of the unit restarts with the factory default
settings and enter normal operation automatically.
Penta manager software
For description of the Penta manager software please refer to the software user guide. Note that when the
DX32R is a part of an NTP router system, all management of the unit is handled by the control system.
Below is a screen dump of the basic/opening control window of the Penta manager software.
