NTM EZ-Counter, Руководство по эксплуатации и обслуживанию

Страница: 6 / 18

EZ-Counter Manual
3
Home
When the controller is turned on, after going through the startup screens, it
will automatically go to the home screen.
Note: After 30 minutes of
inactivity the controller will power itself down.
Overview:
The controller is able to store (50) different lengths, designated by “Job”.
The length is programmed in the upper section of the Home Screen. The
Miters button/light will indicate if any miters are programmed for that
job/length. The Run button will start the machine and will run until the
programmed length is met. The bottom section of the Home Screen
displays the current position which can be set back to zero by pressing the
Reset button. The F and R buttons will jog the machine Forward and
Reverse.
Figure 2: Home Screen (ft/in.)
Figure 3: Home Screen (in.)
Figure 4: Home Screen (cm)