NTI ST-2C5V-L-600, Инструкция по установке и эксплуатации, Страница: 16 / 27

NTI XTENDEX 600 Foot Extenders
13
Installing The Remote Unit (models with only KM connectors)
1. Position the Remote Unit such that the CATx cable, the keyboard cable, mouse cable and power supply cable can each
reach the Remote Unit without putting strain on the cables.
2. Connect the keyboard to the purple female 6 pin miniDIN connector on the Remote Unit.
3.
Connect the mouse to the green female 6 pin miniDIN connector on the Remote Unit.
Figure 9- Connect keyboard and mouse to Remote Unit
Connect the CATx cable
Models With One Remote
Make sure the CATx cable has been installed in accordance with the “Preparation for Installation”
instructions on page 3. Connect the CATx cable to the “Cat 5” port on the Remote Unit. (See Figure 10.)
When properly inserted the CATx cable end should snap into place.
Note: If an RJ45 wall outlet is being used, connect the other end of the extension cable to the RJ45 wall outlet.
WARNING: Never connect the XTENDEX to an Ethernet card, Ethernet
router, hub or switch or other Ethernet RJ45 connector of an Ethernet device.
Damage to devices connected to the Ethernet may result.
WARNING: The CATx connection cable used between NTI XTENDEX Series Local
and Remote or any XTENDEX Series products must be wired straight through (pin 1
to pin 1, pin 2 to pin 2, etc.) The use of a CROSSOVER CABLE will damage the
extender and void your warranty.
Figure 10- Connect the CATx cable to the Remote Unit
!
Front View
PS/2 KEYBOARD PS/2 MOUSE
Remote User's Keyboard and Mouse
6 pin miniDIN
Female Connector
NTI
R
Network Technologies Inc
XTENDEX
ST-C5KM-600 Remote Unit
-
+