9
E-AVDS-GSM
Configuration
By default, the E-AVDS-GSM will perform a self-test upon start up after which it will enter working state indicated by the display of a “1”
or “2” and a flashing decimal point on the lower right corner of LED display.
A slow flashing decimal point indicates normally working state.
A rapid flashing decimal point indicates there is no GSM communication.
If an SMS message and/or voice message have been programmed and saved, and a phone number and contact method have been
programmed into at least one “Ex” button, the E-AVDS-GSM will automatically alarm as soon as it receives an alarm signal.
Use the following to configure programming, enter or review phone numbers, program SMS messages and/or program voice
messages. (If GSM signal level is 0, please check antenna position and installation)
To exit programming mode at any time, press <ENTER>. The LED will display a “1” or “2” to indicate a normal working state.
1. Enter Programming Mode
Press <PAUSE>
+
private password (4 digits)
+ <
ENTER>
Note: Default
password:
0911
Example:
PAUSE
+
0911
+
ENTER.
If password input is correct, “5” will be displayed and the dialer will enter the programming mode.
If password input is incorrect, “E” (meaning error) will be displayed and the dialer will return to a normal working state.
2. Program and Review Service Provider Contact Number
By default, the E-AVDS-GSM will automatically search for and program the contact number of the service provider when the unit is
powered ON.
To check that a number is programmed, in a programming state (in “5” state): press <3> and <0> . The dialer will display the service
provider phone number followed by two beeps.
To clear and refresh the service provider phone number, press <0> and then <ENTER>. The LED will display “A” to indicate a correct
input. It will then automatically search for and re-program the service provider contact number.
To manually enter the contact number, press <0> and then enter the service provider contact number, followed by <ENTER>.
For example: 0+1586ENTER,
The display will return an “A” is the input has been done correctly.
We recommend letting the E-AVDS-GSM automatically acquire the service provider contact number.
3. Program Alarm Buttons and Alarm Method
This dialer supports two methods of reporting an alarm
1)
voice alarm 2)
SMS alarm
Up to 8 separate messages, voice and/or SMS, can be programmed to be sent when an alert is triggered.
In programming mode, press <E1>,<E2>…<E8> to select which one of the 8 programs will be configured. “
三
” will appear.
Enter the phone number to be dialed to reach the recipient of the message.
Press <ENTER>. The LED will display “A” if entered properly, “E” if incorrect.
Press <1> if a voice message will be sent or press <2> if an SMS message will be sent, followed by <ENTER>.
The LED will display “0” if entered properly, “E” if incorrect.
The dialer will then return to state “5”.
Example:
E1
+
15860305205
+
ENTER
+
1
+
ENTER.
This programs button E1 with a phone number to receive a voice message.
To delete the programming on any button, press the numbered <E
x>
button (<E1> – <E8>) followed by the <ENTER> button.
To review the saved number and corresponding alarm method:
In programming mode, press <3> and then the <Ex> button to be reviewed. The programmed phone numbers and corresponding
alarm method will be displayed.
Example:
3 + E1/E2/E3/E4 .
The LED will display alarm method (1 for voice or 2 for SMS)
→
”
A”
→
numbers in the phone number, followed by two beeps
when finished.
Содержание E-AVDS-GSM
Страница 7: ...7...
