4
Squeegee Assembly
The squeegee assembly is packed in a box inside of
the main shipping carton. Remove the squeegee
assembly from the box and inspect for concealed
damage. The squeegee assembly has a wide, flat
frame to help prevent damage, two ( 2) mounting
knobs, and two (2) small wheels to prevent “rollover”
in reverse.
To install the squeegee assembly:
• Place the squeegee lift arm in the storage (up)
position.
• Loosen the two mounting knobs and slide the
squeegee assembly onto the mounting plate. The
roller wheels must face the operator.
• Hand tighten the mounting knobs. Do
not
use tools
to tighten the knobs as this will defeat the
“breakaway” design.
To adjust the squeegee assembly:
As the machine is used, the squeegee blades will
wear or need to be replaced due to damage. Some
adjustment may be needed.
• Squeegee blades should lay over slightly (like a
window squeegee) when the machine is moving
forward or in reverse.
• Adjust the blade angle by turning the wing nut on
the pivot arm clockwise/counterclockwise.
• Do not add any weights or other pressure to the
squeegee mechanism. It will not improve the
performance or service life.
To install a brush or pad driver and pad:
There are a wide range of pads or brushes available
for the many cleaning applications of this machine.
Consult your local NSS distributor for application
recommendations.
• Turn off all switches and empty all liquids from the
recovery and solution tank.
• Raise the brush motor into the “up”
position. The foot pedal is at the rear left of the
machine. Step on the pedal and slide it to the right
into the notch.
• Step on the foot pedal latch at the
front
of the
machine chassis.
• Lift the machine body by the opening for the
solution tank. Tilt the machine body backward until
the handles rest on the floor.
For BRUSH Attachment:
• Align the notches of the brush with the lugs of the
drive casting.
• Turn the brush clockwise to lock onto the drive
casting.
• Turn the brush counter-clockwise to remove.
For PAD DRIVER and PAD Attachment:
• Remove pad driver assembly from drive casting
on end of brush motor shaft by turning the driver
counter-clockwise.
• Turn the pad driver upside down on the floor.
Remove the pad holding cup.
• Remove the center cutout of the 17” (43cm) or 17”
(43cm) pad if present and place pad on the face of
the pad driver. The pad
must be centered
on the
driver to prevent wobbling or bouncing.
• Install and secure the pad holding cup to the pad
driver. Turn the pad driver over so that the pad
faces the floor.
• Align the notches of the pad driver with the lugs of
the drive casting.
• Turn the pad driver clockwise to lock onto the drive
casting.
Control Panel
The operator control panel is located at the rear area
of the machine. This panel has components that
control various machine functions.
Starting from the
left
side:
• The circuit breaker is for both the brush motor and
the vacuum motor.
• The first switch turns the brush motor on and off .
• The next switch turns the vacuum motor on and
off.
• The battery meter shows the state of charge of the
batteries during operation.
Содержание WRANGLER 1708CB
Страница 7: ...7 NOTES...
