NSS BRONCO 16, Руководство по эксплуатации и каталог запасных частей

Страница: 7 / 20

MAINTENANCE
Routine maintenance is critical to ensure proper
machine operation and cleaning performance.
Perform all maintenance procedures as follows:
WARNING: Always unplug machine before
performing any maintenance.
Daily Maintenance
•
Inspect the cord and plug for any damage.
NOTE: To prevent damage to the AC power cord,
ALWAYS store the machine with the AC power cord
coiled loosely over the machine.
•
Remove the hose from the machine at the end of
each workday, check for obstructions or damage.
Repair or replace as necessary. The wand and / or
tools should be removed from the hose and the
hose should be laid in a loose coil, or hung over
several pegs on the wall. Clean the floor tool and
wand of dirt and / or liquid residue.
•
Empty the tank after each use.
Wet Pickup
•
After each use the machine should be emptied and
rinsed with clean water. Empty liquids and dispose
of according to local EPA regulations. Allow to air
dry.
•
Shake the dirt and / or debris from the filter, if the
machine was used for stripper pickup the filter must
be thoroughly cleaned prior to air-drying.
Dry Pickup
A polyester filter bag is standard on this unit.
Shaking lightly before removing from container will
clean the filter.
•
Shake the debris from the filter bag. The filter bag
must be cleaned after each use to prevent loss of
vacuum suction and possible machine damage.
Weekly Maintenance
•
Inspect the hose for wear.
•
Verify that all daily maintenance has been done.
•
Check all gaskets for damage and to ensure an
airtight fit. Repair or replace as necessary.
•
Vacuum the filter bag to remove imbedded dirt and
maintain airflow.
•
Oil casters and wheels with light oil.
•
Check the float for proper operation.
Monthly Maintenance
•
Verify that all weekly maintenance has been done.
•
Oil casters and wheels with a light machine oil.
•
Replace casters and wheels as necessary.
•
Inspect the floor tools for wear.
Every 4 months (Or 500 hours)
•
Check carbon brushes for wear. When carbon
brushes are 1/2" (1.27 cm) in length return the
machine to an authorized NSS Service center for
service.
•
Failure to inspect vacuum motor for carbon brush
wear can cause severe motor damage and failure.
•
Check filters and gasket seals for wear or damage,
replace if necessary.