Ti-Max NL400 CDE
Installation Manual
OM-E0260E
1. Packaging Contents
3.
Attachment of The Connectors
Check to see that all of the following parts are included
and undamaged.
Thank you for purchasing the Ti-Max NL400 CDE. Read this installation manual carefully before use for safety and keep this
within user's reach.
2. Before Assembling the Tubing
Pass the handpiece side motor cords through the
appropriate openings of the control unit so that the
tubing is fixed securely in the arm and the motor
rests at the desired position for handpieces. (Fig.1)
After properly placing the handpiece side motor cords
in the arm, attach connectors as follows.
Control Box Side Motor Cord
Handpiece Side Motor Cord
Connector
Tube-retaining Ring
(3 pieces, Different Types)
Connector Pin Remover
Fig.1
Opening Parts
Arm
Handpiece Side
Motor Cord
Terminal Side
Control Box Side
Motor Cord
Insert the terminals of each handpiece side motor
cords securely to the ends of the holes of the
connectors, paying close attention to the positions of
the cord colors and numbers. (Fig.2)
■
If it is necessary to remove a terminal from the
connector.
Insert an “Connector Pin Remover” securely into the
opposite side of the connector from the terminal to
be removed and pull out the cord while pressing on
the “Connector Pin Remover.” (Fig.3)
Fig.2
Fig.3
Fig.4
３
２
１
６
５
４
Brown
Connector
Cord
Terminal
Insert them matching the cord
color and number.
Black
Red
Orange
Yellow
Caution
After inserting the terminals of the cords,
gently pull them to check that they are
securely fixed.
Caution
・
After adjoining the connectors, gently pull
them to check that they are securely fixed.
・
After adjoining the connectors, check that
the cord colors of the control box side and
the handpiece side match.
Connector
①
Insert
②
Pull Out
Cord
Connector Pin Remover
Handpiece Side
Motor Cord
1
1
2
Insert the connector of the handpiece side motor cord
assembled in to the connector of the control box
side motor cord securely until they lock. (Fig.4).
1
2