NSI MC 6300, Руководство по эксплуатации

Страница: 26 / 27

10
Trouble Shooting
Checklist
Chases do not work.
•
Make sure a rate has been established with the chase rate slider. The
rate is indicated by the flashing LED located directly above the Chase
button.
•
Make sure a chase is programmed.
Lights on stage do not operate
even though Channel Level
LED’s do.
•
Check that the Master slide control is not set at minimum and that the
Blackout LED is not on.
•
Make sure the Softpatch table is not cleared.
•
Check the channel assignments of the dimmers.
Channel slide controls have no
effect on channel levels.
•
Make sure that the Modify function is active and that the channel slider
has matched the channel’s current level.
•
Check the Softpatch table.
•
Make sure the console is outputting the proper output protocol.
Stage lights are on, but will not
respond or respond erratically.
•
Check the channel assignments of the dimmers.
•
Check for a bad control cable by replacing it. If the cable is longer
than 100 feet, try a shorter one.
•
Make sure the console is outputting the proper output protocol.
•
The dimmer pack may be defective.
Program button inoperative.
•
Locked. Check Configuration menu for Program lock.
Reset
and
Memory
Clear
The following procedure causes the entire memory of the console to be cleared and factory
default parameters to be installed. All programming and Softpatch will be lost. This procedure
may be used to clear the console to a known starting point prior to new programming or
rental.
1.
Remove power.
2.
Hold down the following buttons: Pile, Toggle, Program and Configuration
3.
Turn power switch on while holding the buttons down.
4.
Release buttons after 2 seconds.
Memory will be cleared after a few moments. A default softpatch will be installed.
Trouble Shooting MC 6300
Checklist Software Revision 1.00 and above
20
NSI CORPORATION