NScessity NSBAM-169, Руководство пользователя

Страница: 3 / 5

INTRODUCTION 4
Thank you for purchasing the NSBAM-169 Wireless Baby Audio Monitor.
The built-in microphone of the transmitter will pick up your baby’s sounds and
transmit them to the portable receiver. The receiver also features an LED sound
bar that makes sound visible with lights.
Since the communication is wireless, interference may occur during operation.
You can try to reorient/relocate the units and/or to use a different channel on
both units to correct/improve the quality of communication.
CAUTION
PLEASE READ ALL THE INSTRUCTIONS VERY CAREFULLY BEFORE
USING THIS PRODUCT.
THIS PRODUCT IS NOT INTENDED TO REPLACE ADULT SUPERVISION
OF CHILDREN.
♦
Replace only with the same or equivalent type of battery recommended by
the manufacturer.
♦
Please dispose of old, defective batteries in an environmentally friendly
manner in accordance with the relevant legislation.
♦
Do not place the units too close to naked flame sources, such as lighted
candles, open fireplaces, etc.
♦
The units should not be exposed to dripping or splashing water or placed
close to objects filled with liquids, such as vases. Nor should they be
positioned where they could fall into water, such as a basin or bath.
♦
The units are designed for indoor use only.
♦
Only use the units under adult supervision and keep out of reach of children.
SETTING UP
How to insert battery
Open the battery compartment and insert one 9 volt battery according to the
polarity. Always remove the battery when the unit is not being used.
To use with mains power
Insert the adaptor plug into the DC jack on the side of transmitter and/or
receiver. Then plug the adaptor into the mains socket.
OPERATION 5
The Transmitter
♦
The transmitter can either be battery operated or powered by AC adaptor.
♦
Position the transmitter at a convenient location that should not be more
than 2 meters from the baby for optimum voice detection.
♦
Switch ON the transmitter by turning the channel switch from OFF to the
Channel 1 or 2 position. The red power light should be ON.
♦
Select the channel for transmission. Transmitter will pick up baby’s sounds
automatically and transmit it to receiver immediately.
♦
Voice Activation sensitivity (VOX) can be adjusted by rotating the switch on
the transmitter.
♦
The Night Light can be switched On/Off by the Night Light switch.
The Receiver
♦
Both battery and external AC adaptor can operate the receiver.
♦
Switch ON the receiver by turning the channel switch from OFF to the
Channel 1 or 2 position. The red power light should be ON.
♦
Please make sure the channel selected is on the same as transmitter.
♦
Rotate the Volume switch until the desired sound level is obtained.
♦
The 3 LED lights indicate the intensity of the sound received. The louder the
sound received, the more of the lights will illuminate.
Trouble-shooting
♦
If the transmitter is placed too far away from the receiver, sound
disturbances could occur or transmission could be terminated. In this case,
move the units closer together.
♦
If the receiver is placed too close to the transmitter, a whistling sound
(acoustic feedback) could occur. Increase the distance between the units or
decrease the volume.
♦
Continuous background noise from the receiver could mean that the
batteries no longer have sufficient capacity and should be changed.
TECHNICAL SPECIFICATIONS
No. of Channels: 2
Frequencies:
40.695MHz / 40.665MHz .
Power Supply: 1 x 9V (006P, 216) battery for or 9V DC output adaptor.