Assembly Method
• Please assemble correctly according to the following sequence.
• Please keep the original packaging for future storage.
FIG 1
FIG 2
FIG 3
FIG 4
Fig 1
Assemble Base Plate
a. Remove the screws from the base plate.
b. Insert the power lead between the front & back base plates.
c. Make sure the holes of front base correspond with the holes of rear base, fig.1
d. Click the two base plates firmly together as indicated.
Fig 2
Fixing Base Plate to Fan
a. Gently up-end the fan.
b. Insert the rotor base of the main unit into the base plate.
Fig 3
c. Align the screws with the rotor base and make sure the base plates are connected firmly.
Fig 4
d.
Place the power cord into the clip slot.
e.
Carefully place fan upright on its base and plug into the mains supply.
How to install the battery of the Remote Control:
1.
Open the cover of battery compartment according to the direction shown.
2.
Install the battery into the battery compartment. Take care of the polarity of the battery, which is
indicated inside the compartment.
3.
Close the battery cover.
NB Please dispose of used batteries responsibly.
Accessory: Remote Control
• Be sure to direct the remote control toward the receiver on the control panel.
• Use the remote control within 5 metres from the receiver. If the remote control is not directed towards the
receiver; the effectiveness will be reduced.
• Do not place any obstacle between the receiver and remote control.
• Please treat your remote control with care. Knocking or dropping will reduce its reliability.
• Please store the remote control safety when not in use.
Operating Instructions
The fan can be operated either manually by the control panel on
the fan unit itself or by the remote control supplied with the product.
It has a digital thermometer to measure and show the
ambient/room temperature upon plugging the appliance into the
power supply. The tolerance is approximately ± 2°C. The digital
thermometer can measure temperature between 0° to 40°C.
ON/OFF
Press to switch on the unit and press again to stop the fan from running.
The room temperature will display as long as the fan is plugged into the mains
supply.
SPEED:
Press “
⊕
” to increase or “Θ” to decrease the speed setting of the fan.
Continue pressing the “
⊕
”or “Θ” buttons until the desired speed is reached.
PRESET TIMER: With power OFF,
Press TIMER button, then “
⊕
” to increase or “Θ” to
decrease to set the timer from 1 to 12 hours delayed start.
TIMER: With power ON
, Press TIMER button, then “
⊕
” to increase or “Θ” to
decrease hours to set the timer from 1 to 12 hours to turn off. Use in conjunction
with the Mode settings on page 7.
OSC
: The Ultimate Column Fan has 3 oscillation modes ~ 90°, 180° and 360°.
Press OSC on manual control panel or on the remote control to start oscillation
function. The corresponding oscillation angle will display on the LCD.
Press once, the appliance will oscillate left and right at 90°;
Press twice, the appliance will oscillate left and right at 180°;
Press a third time, the appliance will oscillate 360° continuously;
Press the OSC button again to deactivate the oscillation function.
ION:
Press the ION button to activate the ion function. The fan will emit negative
(-) ions to help clean & freshen the surrounding air. The blue
icon indicates
the Ioniser is activated. Press again to deactivate ION function.
5
6
Normal Breeze 8 Speed Settings
3 Speed Settings for Mode Choices