INST6210 – 4/09
Installation / Operation / Maintenance
Sentinel Benchtop Ionizing Blower
Model 6210
Changing Voltage
The input power voltage should be set to your specification
as ordered and prior to shipping. It is marked on the box
label and the specification label affixed to the bottom of the
Ionizer. The voltage can be reset to a different AC voltage
by removing the back of the case. NOTE: The AC power
cord MUST always be disconnected before the Ionizer is
disassembled. Reconfigure the voltage jumpers as shown in
the diagram(s) below to match your AC line voltage supply.
Input voltage is selected with the two internal jumpers as
shown below:
115 volt Jumper Settings
230 volt Jumper Settings
Specifications
Air Velocity:
Two speed fan (250 lfpm with fan on high
speed).
Balance:
±
3 volt typical
(Temperature range: 65
°
F to 80
°
F,
Relative humidity: 15% to 65%)
Ion Emission:
Steady state DC with sensor feedback.
Emitter Pin Electrodes:
.050” diameter 316 stainless steel;
8 required.
High Voltage Power Supply:
5.5 kV DC nominal;
(1) positive HVDC and (1) negative HVDC
Input Power:
AC line power, internally selectable for
100/120 VAC, 50/60 Hz, 1 phase or
200/240 VAC, 50/60 Hz, 1 phase
Fuse:
250 mA slow blow; located at AC inlet inside
rear cover; 2 required
Chassis:
Powder coated aluminum or steel housing
Weight:
7.0 lbs. With cord; 7.4 lbs. Shipping weight with
Packaging
Dimensions:
Width: 6.76” (8.08” with knobs)
Height: 9.82” (with stand)
Deep: 3.77”
Mounting:
Bench top tilt adjust frame with locking knobs;
can also be wall or shelf mounted.
Ozone:
Less than 0.005 ppm
Power
Jack
Voltage
Selection
Header
Jumpers
Power
Jack
Jumper
Voltage
Selection
Header
