04
05
When the battery of the emitter is low, the red light below will flash ,
otherwise it will not light. When the battery of the receiver is low, the
red light above flashes, otherwise it is always on; the user can adjust
the sensitivity on the right to achieve the best scanning effect
according to the usage scenario.
NOTICE
Power on
Short press
SET
Short press
SET
Short press SET
Your excellent helper in measuring instruments.
Your excellent helper in measuring instruments.
Basic
tracing
AC filter
tracing
PoE switch
Cable tracing mode switching graphic
3)PoE
switch
Emitter:
In AC
filter mode, short press “SET” key to enter POE
scan
mode, then
the indicator
flashes
red
and
blue, which
means
the
emitter
works
well.
Connect
one
end
of
network
cable
to
the
RJ45
port
of
launcher.
Receiver:
Push the key to “AC
Filter”
to enter PoE
switch mode, the
brightness
of indicator and
the sound of the speaker is
dynamically
changed according to the signal
strength, which
means
the
receiver
works
well, then hold the receiver to find the target line.
2. Tracing mapping ( RJ45 as an example)
1. Connect two ends of network calbe to the RJ45 port of launcher and receiver separately.
2. And push the key to “test”, the wire sort indicators will flash, which means the
transmitter works well.
3. If the wire is normal, and the GND is not connected, then the 8 indicators will flash
one by one. And if GND is connected, then the 1 to 8 and G indicators will flash one
by one.
4. If there is miswires as below. If line“2” is open, then the 2 indicator of emitter and
receiver will not flash. If there is several lines are open, the corresponding indicators
will not flash. And if less than 2 lines are connected, none of the lights is on.
When the line are cross, for example, line“2” and line“3” disorder, the indicators
flash as follows,
Transmitter : 1-2-3-4-5-6-7-8-G
Receiver: 1-3-2-4-5-6-7-8-G
When there is short circuit of line“2” and “3”, the 2 and 3 indicators of receiver will
not flash while the other lights still do.
The wire tracker has three mapping modes as below:
1) Fast mode(0.5 second)
Emitter: Push the key to “test” to enter Fast mode, the wire sort indicator flashes, then
the LED indicator will flash by one bye one per 0.5 second.
2) Slow mode(1 second)
second
Emitter: In the fast mode, short press the “SET” button to enter the slow mode, the wire
sort indicator flashes, then the LED indicator will flash by one bye one per 1
.
