Operation methods
Usage of transmitter
Open battery cover, install DC 9V battery in launcher,
push the key to “scan”, the indicator flashes, which means the
transmitter is normal. Connect two ends of network line to the
RJ45 port of launcher and remote identifier separately. then
hold the receiver to find the target line. (If you want to alter its
frequency,press the button of “Set”). Push the key to “test”,
the “VERIFY” indicators will flash. Connect two ends of
network line to the RJ45 port of launcher and receiver
separately, then go ahead with the test result. (If you want to
adjust its speed, press the button of “Set”) .
Usage of receiver
Open battery cover, install DC 9V battery in launcher,
push the key to “scan”, the indicator flashes, which means
the transmitter is normal. Connect two ends of network line to
the RJ45 port of launcher and remote identifier separately.
then hold the receiver to find the target line. when the probe
is close to the target cable among plenty of cables, you will
hear “beep, beep”, and the voice is the loudest, the signal
light would be brightest. (Sometimes there may be some
noise, it is difficult to distinguish which one is the goal, here
you can turn down the voice to the best status.)
Your excellent helper in cable test!
05