NVIP
-
3SD
-
6300/30/F
-
User
’
s manual (short form) ver 1.0
All rights reserved © AAT Holding S.A.
10
2.3. Camera mounting
To mount a camera please follow the instructions below:
•
Unscrew the top camera part and unplug wires (
1
).
•
Put the bracket to the wall in a desired mounting place (with cable hole). Take the drill pattern
and mark future drilling holes for screws and wires.
•
Drill holes in accordance with previously done markings and base hole placement.
•
Mount the camera bracket using the supplied plugs and screws.
•
Mount the muff to the bracket (
2
).
•
Mount top camera part to the muff (
3
).
•
Mount camera to the bracket (mount to hinge) and plug in wires. Move camera to bracket and
tighten to the stop counter screws
(
4
).
CAUTION!
Please note that the wall or ceiling must have enough strength to support the IP Camera.
CAUTION!
In order to obtain declared degree of protection please seal the camera bracket to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop
-
through ones, seal them too.
START
-
UP AND INITIAL CAMERA CONFIGURATION
1
3
2
4
