NVIP
-
2VE
-
4231/WL, NVIP
-
2H
-
4231/WL Quick start guide version 1.1
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
8
2.3. "Two way power" function
The camera is equipped with the "Two way power" function. When the camera is connected to the PoE
switch, 12VDC is available in the 12V camera power socket. This allows user to power the receiver
with low power consumption from the camera power socket.
2.4. Camera mounting
2.4.1. Mounting the NVIP
-
2VE
-
4231/WL camera
•
Unscrew the ring that secures the camera to the base, remove the cover and the clamping ring,
take the camera out of the base.
•
Use the template or the location of the holes on the base of the camera to mark the points for
future mounting holes and the cable entry.
•
Drill mounting holes and a hole for the signal cable.
•
Attach the camera base
•
Connect the camera cables, place the camera on the base, put on the cover and pre
-
screw the
fixing ring. Adjust the position of the camera
•
Tighten the clamping ring as far as it will go
2.4.2. Mounting the NVIP
-
2H
-
4231/WL camera
•
Place the camera foot or template on the installation site
•
Mark the points for future fastening holes and the cable entry.
•
Drill mounting holes and a hole for the signal cable
•
Fix the camera using the provided dowels and screws.
•
Loosen the HEX screws that secure the handle and the foot
•
Adjust the position of the camera, tighten the counter screws
Caution:
Please note that the wall or ceiling must have enough strength to support the camera.
Caution:
The declared degree of protection of the camera relates to its housing and does not take into
account the possibility of moisture infiltration into the interior of the camera by connecting
cables. Connection cables protection through i.e. sealing up is the responsibility of the camera
installer. The manufacturer is not liable for any damages to the camera caused as a result of
failing in performing that activity by installer, which also means that camera damaged in that
way is not subject to warranty repairs.
START
-
UP AND INITIAL CONFIGURATION
The maximum power consumption of the device using the
“
Two way power
”
function is 3W.
