NOVO 485MM-100, Инструкция по установке и эксплуатации

Страница: 10 / 24

10
System Start-Up
1. Plug the valve into an approved power source.
2. When power is supplied to the control, the screen will display “INITIALIZING WAIT
PLEASE” while it finds the service position.
3. Start an Immediate Manual Regeneration. The valve will immediately start moving to the
BACKWASH position.
4. Open the inlet on the bypass valve slowly and allow water to enter the unit. Allow all air
to escape from the unit before turning the water on fully then allow water to run to drain
for 3-4 minutes or until all media fines are washed out of the softener indicated by clear
water in the drain hose.
5. Press any button to advance to the RINSE position. Check the drain line flow. Allow the
water to run for 3-4 minutes or until the water is clear.
6. The valve will automatically advance to the SERVICE position after the RINSE cycle is
complete. Open the outlet valve on the bypass, then open the nearest treated water fau-
cet and allow the water to run until clear, close the tap and replace the faucet screen.
7. Program time, date, and number of days between regenerations into controller using
Programming Instructions
Start-up Instructions
Key Pad Configuration
SETTINGS This function is to enter the basic set up infor-
mation required at the time of installation.
MANUAL
REGEN This function is to initiate an immediate or
delayed manual regeneration.
DOWN /
UP Increase or decrease the value of the settings
while in the programming mode.
DELAYED REGENERATION
Press and release the MANUAL REGEN. But-
ton to set a delayed regeneration that will
occur at the regeneration time. The main
display page will show DELAYED REGEN ON.
To cancel press and release the MANUAL RE-
GEN. Button. The main display page will
show DELAYED REGEN OFF.
IMMEDIATE REGENERATION
To start an immediate regeneration (or step
valve through each position), press and hold
the MANUAL REGEN. Button for 3 seconds
(until beeps). The valve will start an immedi-
ate regeneration. Press any key to skip to
the next cycle.
Manual Regeneration (Step / Cycle Valve)