Novo Nordisk NovoPen 3, Инструкция по эксплуатации

Страница: 16 / 22

12
Important notes
■
NovoPen
®
3 must be handled with care, do not drop it and
avoid knocking it against hard surfaces.
■
Protect NovoPen
®
3 against dust and dirt when it is not in
its case.
■
Make sure that the piston rod is completely inside the
return mechanism before you screw together the mechanical
section and the Penfill
®
holder (see point 4).
■
Always screw the mechanical section and the Penfill
®
holder
tightly together.
■
Always prime to expell air with the needle pointing upwards
before each injection (see point 8).
■
The coloured band on Penfill
®
tells you which type of insulin
Penfill
®
contains. Before each injection make sure that you
are using the right insulin preparation.
■
Before injecting always check that there is enough insulin
left for your dose. After the injection make sure that the
dosage indicator window reads 0. If not, see point 14.
■
Do not initiate injection of an insulin suspension
(cloudy insulin) if the rubber piston can be seen in the
small inspection window.
■
Do not use the residual scale to measure the amount of
insulin to be injected.
■
Take the needle off NovoPen
®
3 immediately after each
injection. If you do not remove it, temperature changes
may cause liquid to leak out of the needle. With an insulin
suspension (cloudy insulin) this may change the
concentration of the insulin.