6
03/10 Rev. 5.04-01
USER MANUAL
Mounting & Setting
LA-BO
Fitting the applicator
1. Remove the apply roller from the dis-
pensing edge (1) and then remove the
dispensing edge from the dispenser arm
fixture by loosing the M8 bolt (2). Remove
the black bracket from the dispenser rods
by releasing the 2 M5 bolts (3) at the bot-
tom side.
2. Slide the aluminium bracket of the LA-BO
over the 2 dispenser arm rods (1) and
tighten the screws (2).
3. Remount the black bracket on the dis-
penser arm rods (1) and adjust the height
of the LA-BO so that there’s a distance of
approximately 39 mm to the black
bracket for the dispensing edge.
Remount the dispensing edge of the
ALS 20X/256 (2).
4. Plug the cable of the LA-BO into the high
density D-sub connector in the AI-board
at the back side of the ALS 20X/256 or
into the D-Sub 15 connector when using
Internal Applicator Interface (adaptercon-
nector A9103 necessary). Install the
included filter regulator somewhere close
by the LA-BO, e.g. on the support stand
of the ALS 20X/256. Connect the LA-BO
to the filter regulator. Connect the com-
pressed air to the filter regulator.
