01/13 Rev. 5.05-01
USER MANUAL
Attachment, Setup
Rewinder
2000
15
Inserting material
Direction of rotation
The material – depending on the set direction of rotation – is wound around
the core in a clockwise or anti-clockwise direction (see Fig. 5).
Fig. 5 Left side: direction of rotation = left (labels outside); right side: direction of rotation =
right (labels inside)
Proceed as follows:
1. Remove the guide disk (1). To do so,
open the clamping lever (2). Remove
the clamping bar (3).
2. Feed the end of the material web around
dancer arm and winding core and fix it
with the clamping bar. To do so, push
the clamping bar over the material (4).
If a cardboard core is used: Push the
clamping bar underneath the cardboard
core.
Continued overleaf.
1
2
1
3
4
