Novell OPEN ENTERPRISE SERVER - CONVERSION GUIDE 12-2010, Руководство по внедрению

Страница: 116 / 296

116 OES 2 SP3: Planning and Implementation Guide
Configuring for DA Access Before or After Installing the OES 2 Server
Whether you configure DA access before installing OES 2 on a SLES 10 server or after a
simultaneous install of SLES 10 and OES 2, the manual DA configuration process is the same.
1 Open
/etc/slp.conf
in a text editor.
2
Find the following line:
;net.slp.useScopes = myScope1, myScope2, myScope3
IMPORTANT: The example in the configuration file is misleading because the spaces after
each comma are not ignored as one might expect them to be.
Therefore, the scope names created or configured by the statement after the first comma
actually have leading spaces in them. For example, the first scope name is “myScope1” but the
scope names that follow it all have leading spaces, “ myScope2”, “ myScope3” and so on. This
is a problem, especially if one of the later names becomes the first name in a subsequent SLP
configuration and the leading space is ignored.
If you use the scopes given in the example for some reason, remove the spaces between the
entries.
3
Modify the line by removing the semicolon and typing the name or names of the scopes you
want this server to have access to. Be sure to include the scope you defined in
Step 4 on
page 114 .
For example, you might change the line as follows:
net.slp.useScopes = Directory
4
Find the following line:
;net.slp.DAAddresses = myDa1,myDa2,myDa3
5
Modify the line by removing the semicolon and typing the actual IP address of the OpenSLP
DA you defined in
“Setting Up an OpenSLP DA Server” on page 114 .
net.slp.DAAddresses = IP_Address
6 Save the file and close it.
7
At the Linux command prompt, enter the following to restart the SLP daemon and reset its
configuration:
rcslpd restart
Configuring NetWare Servers to Use the OpenSLP Service
IMPORTANT: NetWare uses Novell SLP by default and will configure a server for that service if
possible.
Complete one of the following as it applies to your situation:

“Configuring for DA Access During the NetWare Server Installation” on page 116

“Configuring for DA Access After Installing the NetWare Server” on page 117
Configuring for DA Access During the NetWare Server Installation
1
In the dialog box where you set up IP addresses for network boards, click Advanced .