Novatron Xsite EASY, Руководство пользователя

Страница: 45 / 55

8.4 Slope digging, moving the excavator
When moving the excavator, its altitude always changes. To maintain the original reference level,
the bucket must be taken to a certain reference point before and after moving the machine, or a
rotating laser has to be used.
Note
When moving the excavator, it is advisable to use a laser to achieve the best
possible accuracy (see chapter 8.4.1).
8.4.1 Moving the excavator with a laser receiver
Tilt the laser transmitter to the same gradient that has been entered into the system. Set the laser
transmitter to any height. Go to the “Main menu” → “Laser”. Press “Right arrow” twice to enter
page 3/3 and set the laser to ON. It is also possible to control the laser with the “Power” button
(see chapter 2.3.5).
Move the boom slowly so that the laser receiver hits the laser beam. It is advisable to move the
dipper stick to as upright position as possible when reaching the laser beam. The laser receiver
symbol on the screen indicates laser hits. The laser hit has been accepted when the text “Hold!”
changes to “Hit accepted!” and the black background changes to a white background (Figure 51).
Figure 51. Moving the laser receiver to the beam. The laser receiver symbols indicate laser hits
and acceptance
Zero the reading to the slope starting point (Figure 52) (“Starting level” = “0.00” in this example).
Xsite EASY | User manual | Page 42 of 52
Figure 52. Zeroing the reading