4
Clearing Overlays
Overlay banks can be cleared using
Novation Components
via the AFX Mode page. The default
overlay banks can also be restored from this page.
Individual overlays can be cleared individually via Sysex (see ‘Sysex Support’ below).
Copying Overlays
It is possible to copy and paste overlays from one note to another on the hardware.
Press and hold
Function
+
Transpose
(in that order) to enter copy-paste mode, this is only available
when a bank of overlays is selected. Whilst holding
Function
+
Transpose
, press and hold a key to
copy an overlay (“CPY” is shown on screen when the overlay is copied). With copied key still held,
the overlay can then be pasted to any key by pressing the desired key (‘PST’ will be displayed on
screen). An overlay can be pasted onto any number of keys.
Protecting Overlays
It’s possible to write-protect your overlays to allow you to make performance changes to the synth
without accidentally changing the overlays. To enable write-protection hold
Function
and press the
Seq-Retrig
key twice, then change r-0 (read-only disabled) to 1 (read-only enabled).
This write-protection applies only to the overlays.
Overlay Parameters
For a full list of the parameters stored in overlays see the table at the end of this document.
Overlay parameters are only those values that apply on a note-by-note basis. Arpeggiator settings
and global (voice) settings are not included. Most surface controls and on-key parameters are
included.
