Chapter 2 RELAY7 Installation
RELAY7 User Manual v3
18
Figure 5: Attach RELAY7 to SMART7
1. Ensure cable connections for the Ampseal interface and Ethernet (model dependent) cables
are complete. Refer to
RELAY7 Cable Routing to SMART7
2. Tilt the RELAY7 unit slightly up and slide onto the SMART7 unit in the locations marked by the
four arrows (
).
3. Hand fasten the M4 screws (x4). Bit required: M2.5 Hex, torque = 10 to 12 in-lb. Failure to
properly install the four screws may cause damage.
4. If using the optional Ethernet cable (NovAtel 01020095), insert the M12 Female end down
and into the RELAY7 cable channel. Press cable firmly into the channel to lock in place.
Once complete, flip the combined SMART7/RELAY7 over. The optional NovAtel interface cable or the
vehicle's cable attached to the navigation system can be used to connect to the RELAY7 and power the
combined units. Refer to
Connect the RELAY7 to the Radio Antenna Mount
on the next page for instruc-
tions. Also refer to
SMART Antenna Interface Cable (Optional Accessory)
on page 40 for interface
cable details.
To prevent damage or cable fatigue, ensure any loose cables are secured.
