Novatel Ovation MC551 Скачать руководство пользователя страница 5

Novatel Wireless Inc.

 

 

Version 2.0 

12/15/2011 

 

5 of 8 

 

3.0 Module Installation Guidelines 

The MC551 must be installed for use internal to final products where the 

separation distance between the user and the modem is greater than 2.4cm 
(24mm). Refer to 

Section 5.0

 

OEM Integration Requirements 

section for 

measurement guidelines for separation between the transmitting antenna and the 
user. The modem must not be collocated with other antennas or transmitters unless 
the guidelines within this document are followed. See 

Section 4.0

 

Collocated 

Installation Guidelines

 for collocated information. 

 

4.0 Collocated Installation Guidelines 

This section applies to all combinations of transmitters and antennas installed 

in the final product. The addition or use of the MC551 with other radio transmitters 
must be evaluated to ensure that RF Exposure conditions do violate any FCC rules. 
It is not recommended that other transmitters be used with the MC551 however 
should the installation utilize other transmitting devices care must be taken and 
these steps need to be followed. Please contact Novatel Wireless to oversee the 
setup of the modem with multi radio configurations. 

 

Collocated transmitters can be operated simultaneously with the MC551, provided 
the conditions listed below are met:  

i) 

A list of the FCC IDs must be presented to Novatel Wireless.  

ii) 

A distance of at least 5cm (50mm) must be maintained from other transmitting 
devices (such as other USB devices).  

iii) 

Any combination of transmitting antennas must maintain a separation 
distance of at least 5cm (50mm) from each other.  

iv) 

Authorization from Novatel Wireless is required before operating two or more 
wireless transmitters with the MC551.  

 

The application of the Novatel Wireless FCC ID as stated in section 1) iv) is 

conditional based on the guidelines above. All integrations that involve multiple 
transmitters must be reviewed and approved by Novatel Wireless. Authorization to 
apply the Novatel Wireless FCC ID on the exterior of the host device must be 
provided prior to installing and turning these devices on. 

 
 

Содержание Ovation MC551









Отзывы: