*www.novatekco.com * toll free 866.563.7800 * tele 610.363.7800 * fax 610.935.1945 * [email protected]*
5
SECTION I
GENERAL
This operation and maintenance manual is furnished with each Duravent unit. It outlines general equipment use and the
operation and maintenance requirements for efficient and safe operation.
READ ALL INSTRUCTIONS AND DATA IN THIS OPERATION AND MAINTENANCE MANUAL PRIOR TO OPERATION
OF THIS EQUIPMENT.
These instructions are for your protection and convenience. Please read them carefully since failure to follow the
precautions could result in injury. Whenever using electric powered equipment, basic safety precautions should be
followed.
If after reading this manual anything seems unclear, contact a
NOVATEK
authorized distributor or
NOVATEK
directly by
dialing 1-866-563-7800.
DESCRIPTION
The Duravent is a portable Electric Ventilation/Blower Unit manufactured by
Novatek
Corporation.
This unit has a variety of uses including removal of non-hazardous dirt or dust, drying carpet or damp areas, adding needed
ventilation to enclosed areas. Coverts air flow from intake to exhaust in mere seconds.
The Duravent requires a 110/115v-60Hz, single-phase power source.
WARNING
Do not start the unit if you see signs of damage to the fan blades, guards, housing, motor or cord. If the
unit shows any of these signs, further damage or injury may occur. Do not use circuits exceeding specified
voltage. Higher voltage will damage controls and could cause shock or fire hazard. Do not use in explosive
environments.
SECTION II
PRIOR TO USE
1. Remove excess dirt or dust from the exterior housing, cord plug and switch.
2. Be sure the unit is sitting on a flat stable surface.
3. Be sure the unit is connected to a grounded 110/115 volt outlet.
4. Be sure intake and exhaust ports are free from dirt and debris.
START-UP
1.
The Duravent should be positioned at the center of the room away from worker’s access openings.
2. Connect intake side or exhaust side to hose canister if flex ducting is required.
3. Turn unit on and check for consistent airflow.
4. Turn off unit if excessive noise or vibration occurs. Check rubber feet or fan blade for damage. Replace any missing or
damaged parts at this time.
SECTION III
SAFETY AT WORK
The Novatek Corporation Duravent is a highly efficient system designed to help eliminate any air borne particulates. In order
to properly operate these units effectively and safely, the following safety precautions should be strictly adhered to:
Do not leave unit unattended when connected to the power source. Turn OFF electric supply and disconnect from
power supply every time the unit is not being used and or before service.
Do not operate with damaged and or malfunctioning parts. If the unit is not working as specified in this manual
make sure to repair damaged parts or return to an authorized repair service center.
Keep loose clothing and all body parts away from fan blades when in operation.
Содержание Duravent V1000
Страница 1: ...1...
