NWB & NWB-HC IM28 OCT 2014
Page 9
Instruction Manual NWB & NWB-HC IM 28 OCT 2014
5.3 Electrical Connections
The NWB Series dryer comes from the factory with all control circuits wired and the dryer
needs to be connected to the proper power source.
CAUTION:
All electrical connections must be made by qualified electricians, per national and
local electrical codes.
Disconnect and lock out the main power source before making the electrical
connection.
Procedure:
1) Turn di
sconnect on the door to the “OFF” position, lock out the main power source and
open the electrical enclosure.
2) Per the electrical diagram, install the main power wire to the main disconnect switch
holder and install the ground wire.
Full size electrical drawings are included with this Instruction package for the
voltage of the dryer you ordered.
NOTE: Please make sure that all electrical connections are tight. It is not common but a
loose connection is possible after a long truck ride.
NOTE: 3 Phase detection is included on this model.
If the connection is not correct, a pop-up alarm will
appear on the touch screen upon startup. You
should immediately correct this condition.
