It is advisable to wear ear defenders when removing the siren from the wall as
the tamper alarm will sound when activated. Another person will be needed to
disarm the siren from the keypad immediately.
1. With the siren removed from the wall, remove its rear cover.
It is also advisable to wear ear defenders at this stage during the learning
process also as the siren will sound
2. Press the LEARN button once on the siren to enter learn mode. The red learn LED
will be lit on the pcb for approximately 30 seconds.
Note that if the sensor is activated when picked up, then wait for the green LED to turn off first
before pressing the LEARN button on it
3. Press the LEARN button once on the pcb of the door/window contact sensor. Its
LED will flash green rapidly and the siren should produce 3 beeps to indicate
successfully linked.
Note: If no learn signal is received by the siren within approximately 30 seconds, the learn
LED on the siren will turn off and the siren will exit learn mode automatically.
4. Wait approximately 30 seconds for the siren to exit learn mode or press the
LEARN button once on the siren to exit learn mode manually.
5. Refit the back cover and re-install the siren again on the wall. Note that if the
tamper switch is activated again, another person may be required to disarm it from
the keypad by entering the 4 digit password and the DISARM key.
How to know if the siren has too many devices linked to it
If during the learning process the siren produces 4 beeps then this indicates it has 10
devices already connected to it.
INSTALLING THE DOOR/WINDOW CONTACTS
1. Using the supplied fixings or double sided tape pad, mount the back casing of the
sensor on the door/window frame and the magnet part on the door/window using the
double sided tape pad supplied as shown on the next page. Only install the unit in
dry interior locations.
Note: If using the screws provided, you may need to remove the batteries before
installing the back casing on the door/window frame and then insert them again
afterwards