Novanta Precession Elephant 2, Руководство пользователя

Страница: 35 / 103

PRECESSION ELEPHANT 2 Scan Head 2 Instruction Manual 2021-09-22
3. If the device is not present then create, configure and activate it as described in
document [ InScript ] chapter
Managing Devices
and in document [ Firmware ]
chapter
Devices  Miscellaneous  Shutter
.
4. In the
Node Properties
view, check, if the following variables are set to the
values listed below and correct them if necessary.
Parameter Value
Target state open
Current state open
5. Proceed with subsection 6.5.5 on page 35 .
6.5.5 Laser device
Procedure
1. In the InScript software in the
Navigator
view,
in the controller’s
Devices
subtree,
select your laser device.
2. If the device is not present then create, configure and activate it as described in
document [ InScript ] chapter
Managing Devices
and in document [ Firmware ]
chapter
Devices  Laser  <your laser>
–
OR
–
Configurable Laser.
3. In the
Node Properties
view, check, if the variables are set correctly and correct
them if necessary.
4. Proceed with section 6.6 on page 35 .
6.6 Setting up the laser beam
TIP
If an already adjusted scan head is removed from the system and thereafter is mounted
back to the system then all steps from section
6.6 on page 35 and further on have to be
performed again.
This is the only way to ensure optimal performance and process stability.
The laser beam shall run along the scan head’s optical axis.
This can be achieved by at
least 2 mirrors positioned, in beam direction, before the scan head.
35