Flexpoint™ HS-1R User’s Manual
Page 23
Multiple Symbols Mode
This sets the option to
allow you to read multiple symbols with a single pull of the trigger.
If you press and hold the trigger, aiming at a series of symbols, it will read unique symbols once,
beeping (if turned on) for each read. The HS-1R attempts to find and decode new symbols as
long as the trigger is pulled, and the same symbol will not be read more than once. When this
programming selection is turned
Off
, the HS-1R will only read the symbol closest to the aiming
beam. Default = Off.
Multiple Symbol Mode On
* Multiple Symbol Mode Off
Re-read Delay
This sets the time period before the imager can read the same bar code a second time. Setting a
proper re-read delay time protects against accidental re-reads of the same bar code. Use shorter
delays in applications where repetitive bar code scanning is required.
Several commonly used re-read delay menu command barcodes are included below. Use the
command
DLYGDRD
x
(where ‘x’ is a value between 0 and 30.000 in milliseconds)
, or by
building a menu command barcode that includes such a value.
Please contact JADAK if assistance is needed. Default time = 0.6 seconds.
Note:
Re-read Delay only works when in
Setting examples:
No Re-read delay
Re-read delay 0.1 seconds
* Re-read delay 0.6 seconds
Re-read delay 1.0 seconds
Re-read delay 2.0 seconds
Re-read delay 5.0 seconds
