Novanta f201, Руководство пользователя

Страница: 26 / 105

PS-96 AC INPUT SECTION PAGE | 26
Table 2-4 Three-phase AC electrical recommendations.
Parameter Recommendation
Input voltage 105–264 VAC, 3Ø
Input current, max. 23 Amperes (per phase)
Wire gauge 10 AWG
Fuse/circuit breaker 30 Amps
To connect three-phase AC input power to the PS-96 power supply, refer back to the prior figure and perform the following steps:
Figure 2-8 PS-96 interface.
Caution: Possible Equipment Damage
Do not plug and unplug the DC Power cable on the rear of the laser to switch DC power to the laser.
Switching power under load causes arcing that will damage the connector and control board. To
properly cycle power to the laser, switch the AC power source controlling the PS-96 DC power
supply.
Caution: Possible Equipment Damage
All AC input wiring and fusing to the DC power supply must be sized and connected in accordance
with applicable local, state, and national requirements.
Local, state, and national code requirements (like NEC, CSA, and IEC 60364) supersede any
recommendations provided in this manual