6
OVER DISCHARGE PROTECTION
An internal component of the
battery pack is an over discharge
protector. This feature will stop the
battery from discharging beyond the
recommended lowest safety voltage.
OVER HEAT PROTECTION
The battery has an internal Thermister
cut off sensor which will cease the
charging cycle if the battery becomes
hot during the charging process. This
Thermister sensor will also stop the
battery from operating should the
battery become too hot during the
operation of the tool. This can happen
when the tool is overloaded or being
used for extended periods of time.
Up to 30min in cooling time may
be required depending on ambient
temperature and operation being
performed.
OVER CURRENT PROTECTION
Should the battery be overloaded
and the maximum current draw be
exceeded the battery will temporarily
stop working to protect the internal
components. The battery will resume
to normal operation once the
excessive current draw has returned
to normal safe level. This may take a
few seconds.
SHORT CIRCUIT PROTECTION
If the battery pack was to short circuit
the short circuit protector would
immediately stop the battery pack
from operating. This will ensure that
no further internal components of the
battery or the tools are damaged.
INTENDED USE
The LED torch is designed to light up
work areas.
This tool is to be used only for its
prescribed purpose. Any other use
is deemed to be a case of misuse.
The user / operator and not the
manufacturer will be liable for any
damage or injuries of any kind caused
as a result of this.
never overcharged. When the battery
has reached its full charge capacity
the charger will shut off protecting the
internal components of the battery
from being damaged.
