4
Operation:
Assembly Instructions:
Unscrew the
Height Adjustment Control Collar
from the
Outer Pipe
by
turning counterclockwise and set aside. Pull out the
Inner Pipe
all the way
to the top.
(You may have to push it up from the bottom to get it up)
Set the base on a level dry surface removes the screws from the
Base,
then installs the
Outer Pipe
and matches the 4 holes over the 4 screw
holes on the base and replaces the 4pcs of screws back onto the base.
Place the
Base end cap
through the column to cover the cross base
jiont part.
Put the
Height adjustment Control Collar
and tighten by turning clockwise.
Place the fan motor into the top of the inner pipe, tighten the
Set Screw.
Unscrew the
Grill Nut
on the front of the motor by turning
counterclockwise.
Mount the
Rear Grill
on the front of the motor front cover, make sure the
handle up.
Tighten the
Grill Nut
by turning nut clockwise to hold the
Rear Grill
in
place.
Put the
Fan Blade
onto the motor shaft by matching the shafts slots,
tighten the
Blade
with
Blade Cap
.
Test fan by rotating with your hands, make sure there isn’t any contact
with the nut. The fan blade should rotate freely, otherwise repeat all
steps again, beginning from step(4).
Mount
Front Grill
onto
Rear Grill
closed the locking clip.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Set the fan on a level dry surface.
Plug the power cord into a standard AC 220-240V wall outlet.
Press speed key to set the desired speed
a.3=“HI” 2=“MED” 1=“LOW”.
b.Press 0 = “OFF” key to turn the fan off.
To start or stop fan head oscillating, press or pull the oscillating knob on
the top of the motor housing.
Switch off the fan. Slightly adjust the screw on the side of motor parts to
the desired angle.
1.
2.
3.
4.
5.
