12
AFP-3030 Operations Manual —
P/N DOC-01-033:C 05/12/2018
General Information
Navigating Menu and Programming Screens
The second, third and fourth lines always contain the same device information, as follows:
Refer to Figure 1.3 on page 10 for an example of a Point Event Display.
If the fire panel is ALL SYSTEMS NORMAL and a Mass Notification event occurs over the network on a MNS mapped node, the panel
will display NETWORK MN ACTIVE. Refer to VeriFire Tools for MN Mapping information.
Figure 1.5 Network Mass Notification Event Example
1.5 Navigating Menu and Programming Screens
The Main Menu (refer to Figure 1.6) leads to screens with various menu options. Choices may be made from the menu screens by press-
ing the soft key closest to the menu option.
Field information may be added/modified using the keypad and special function keys.
Arrow keys on the keypad can be used to navigate between fields on a screen if there are no soft keys to select the fields.
Pressing a BACK soft key on a screen returns the programmer to the previous screen without saving the information entered.
Pressing an ACCEPT soft key will save information entered on the screen. It may also return to the previous screen and/or perform other
functions as described in the soft key section for each screen.
When the panel can not read a specified point (that is, if the point entered on the screen for processing does not exist in the panel’s pro-
gramming) it will display an error screen for several seconds, then return to the screen where the address was entered. The user must
check his input and investigate the state of the point.
1.6 The Main Menu
The Main Menu screen is the means by which the programmer can access displays, history information, printing and programming
menus. This screen is accessible from the System Normal Screen (Refer to Figure 1.2), and from most other screens by pressing the
BACK soft key until it displays.
M N A L A R M
S E C U R I T Y O F F I C E M A I N B L D G
F I R S T F L O O R Z F 2 0
M N M O N
1 1 : 5 8 : 4 5 A T U E J A N 2 2 , 2 0 1 3
L 0 3 M 0 0 2
Line 2 - Displays the custom
label and the extended label
Line 3 - Displays the primary
zone label, the primary zone
number, and the software
Type ID.
Line 4 - Displays event time,
event date and device
address.
Loop number
Monitor
Device address
O T H E R : 0 O F 0
N E T W O R K M N A C T I V E
1 0 : 3 5 : 1 7 A T U E 2 2 J A N 2 0 1 9
A L M : 0
S U P : 0
F L T : 0
D I S : 0
O T H E R : 0
1 1 : 5 8 : 4 3 A T U E 2 2 , J A N , 2 0 1 9
