E
N
G
LI
S
H
8
3.
Assemble Base Support (J) into the bottom of the Main Unit (A) and secure with four #1
Bolts and four #3 Flat Washers.
ASSEMBLY OF WHEELS
1.
Place #4 Flat Washer onto #2 Bolt and insert into pre-
drilled hole on inside of Base Support (J).
2.
Put #4 Flat Washer and #8 Sleeve Barrel on end of inserted #2 Bolt.
3.
Attach the Wheel (H) to the #2 Bolt. Place #4 Flat Washer and #5 Locking Washer on
Wheel (H). Use the end of the Wrench (N) with small notch to hold the #2 Bolt in
place. While holding #2 Bolt in place, tighten the #6 Nut Cap with Wrench (N).
4.
Repeat on other side, following the directions above.
(#4)
Flat
Washer
(#2)
Bolt
(#4)
Flat
Washer
(H)
Wheel
(#8)
Sleeve
Barrel
(#5)
Locking
Washer
(#6)
Nut Cap