ENGLISH
6
HOW TO OPERATE
1.
Place the unit on a stable, water-resistant surface near an electrical outlet before
starting. Make sure the cord is away from any water source. It is acceptable to
use an extension cord if needed. DO NOT plug in the unit at this time.
2.
Place the Ice Shaving Chamber into the Motor Housing so it is seated on the
shaft. Twist the shaft in the direction of the arrow to lock into position. Make
sure that the Ice Shaving Chamber is free from any foreign objects.
3.
Insert the Mixing Paddle into the slot in the center of the Pitcher.
4.
Fill the Pitcher with your favorite beverage, liquor, juice or drink mix.
NOTE:
Use the Liquid lines indicated on the side of the pitcher as a guide for
how much liquid to add. You may choose to make a Small or Large serving.
5.
Slide Pitcher into place on Base and turn clockwise until it stops. This will allow
the Mixing Paddle to mix ice and ingredients once the operation begins.
6.
Turn the Selector Knob to the desired setting. "SLUSH" produces a
finely shaved ice; "SNOW" produces a coarser textured ice.
7.
Place ice in Ice Shaving Chamber. Add enough ice cubes to reach, but not pass, the top of
Ice Shaving Chamber.
BE CAREFUL when placing ice cubes in Ice Shaving Chamber. The blade is very sharp.
8.
Plug cord into outlet.
9.
When you are ready to start making your frozen beverage, place the Lid on the unit
and turn counter-clockwise to engage the interlock switch (power ON/OFF).
10. The unit will immediately start and begin shaving the ice.
NOTE:
It may be necessary to remove the lid during shaving to redistribute ice.
11. Turn Lid clockwise to stop the FROZEN BEVERAGE STATION from shaving
ice. Stop unit when shaved ice reaches desired "Shaved Ice" level
indicated on the Pitcher. DO NOT shave ice above Max line.
12. To remove Pitcher, turn counter-clockwise, slide out and serve your frozen beverage.
By following these simple instructions, you can use your FROZEN BEVERAGE STATION
to make delightful treats for friends and family!
