Norwood Kwik-Till HSD1600, Руководство оператора, Страница: 74 / 152

4 - WORKING OPERATIONS
4-10
6. Check the Penetration Depth
D
of the Front Row Disks
A
& the Rear Row Disks
B
. Take note of how much
you would like to raise or lower both the front and rear
disk rows - round to the nearest 1/2”.
(See Fig. # 4-22)
C
A C
B
D D
B
A
Fig. # 4-22 Check the Penetration Depth
7. If you are satisfied with this setting proceed with field
operation, if not proceed to step # 8.
8. Repeat steps # 4 thru. # 7 until the proper depth is
achieved.
Transport Locks
The Kwik-Till has two Transport Locks
A
to keep the wings
locked to the hitch during transport, service and storage. The
transport locks are located on the left and right Transport
Rests
D
. The transport locks MUST be installed on the
transport rests securing the wings in the Locked Position
B
whenever the Kwik-Till is transported, serviced, or stored
to avoid the wings breaking free from the transport rests.
The transport locks have a designated Stowed Position
C
on the transport rests. The transport locks MUST be returned
in the Stowed Position before the Kwik-Till is unfolded.
• Remove the Transport Locks
A
from the Locked Po-
sition
B
and install into the Stowed Position
C
when
unfolding. (See Fig. # 4-23)
Fig. # 4-23 Transports Lock Shown In Locked Position
A
B
D
C A
• Remove the Transport Locks
A
from the Stowed Po-
sition
C
and install into the Locked Position
B
before
transport, service and storage.
(See Fig. # 4-24)
Fig. # 4-24 Transports Lock Shown In Stowed Position
B
A
D
B C A