Norwood Kwik-Till HSD1600, Руководство оператора, Страница: 72 / 152

4 - WORKING OPERATIONS
4-8
• Adjust operating speed to 10.5 mph - 11.5 mph (17 km/h
- 18.5 km/h) for best performance.
• Adjusting the Front Disk Height
A
is done by adding/
removing Depth Stops
B
to the two Center Strut Wheel
Cylinders
C
, and the two Wing Strut Cylinders
C
.
(See Fig. # 4-14)
C
B
A
Fig. # 4-14 Adjusting The Front Disk Height
• Adjusting the Rear Disk Height
A
is done by adding/
removing Depth Stops
B
to the four
Rear Roller Cyl-
inders
C
. (See Fig. # 4-15)
B C
A
Fig. # 4-15 Adjusting The Front Disk Height
Understanding Depth Control Components
WARNING
Before disconnecting equipment, servicing, adjusting,
or repairing :
Park on a level surface, engage park brake, place
transmission in PARK, shut off engine, remove key, and wait
for all moving parts to stop before leaving the tractor cab.
• To set the Depth Stops
C
, remove the Hair Pin
A
,
and
the Hitch Pin
B
.
(See Fig. # 4-16)
Fig. # 4-16 Adjusting The Depth Stops Step # 1
B
C
A
• Engage the required amount of Depth Stops
C
, 90 De -
grees towards the Cylinder Rod
E
. Add Depth Stops
C
starting from the Cylinder Stop Plate
D
only.
(See
Fig. # 4-17)
IMPORTANT
Failure to add or remove depth stops from the wrong
end of the hydraulic cylinder will cause hydraulic cylinder
component and hydraulic cylinder damage.
(See Fig. # 4-9)
(See Fig. # 4-10)
A
B
D
C
E
Fig. # 4-17 Adjusting The Depth Stops Step # 2