14
5. To start the machine
a.
GC55: Follow the instructions for starting the engine found in
the Engine manual.
i.
Verify that the emergency stop switch is in the up
position
ii.
Turn Engine On/Off Switch to the on position
iii.
Turn the Fuel Control to the On position
iv.
Engage Choke as necessary
v.
Pull start rope. If the engine does not start within 3-5
pulls of the start rope, refer to the engine owner’s
manual for more information.
b.
GC25E: For Electrical Connections, Extension Cord Set
Information, and Generator Information see section
E.
Electrical Connections GC25E
i.
Verify that the motor voltage change switch is set to
the same voltage as the circuit.
ii.
Verify that the circuit has a 30 Amp breaker installed.
iii.
Verify that the extension cords are the correct gauge,
length, and are properly grounded.
iv.
Verify that the GC25E power switch in the off position.
v.
connect the extension cord set to the machine and
power supply. Follow all local and national electrical
code. If unsure of how to connect the extension cord
set or of the electrical circuit have a qualified
Electrician make all electrical connections.
vi.
Move the start switch to the On position and the motor
should start. If the motor doe not start have a
qualified Electrician inspect all electrical connections
and the power supply
6. For the GC55 be sure the engine is running at full throttle!!!
7. Slowly lower the blade by rotating the hand wheel clockwise until the
desired depth of cut is reached. Use a reasonable rate of feed. Do not
force the blade into the cut!! If the engine starts to die slow down the rate
of feed! If the machine tries to climb out of the cut, slow down the rate of
feed!
8. When the end of the cut is reached, slowly raise the blade out of the cut by
rotating the Hand Wheel counter-clockwise until the blade is at least one
(1) inch above the ground.
9. Only move the saw in reverse with the blade in the raised position.
