Norton CM 351, Руководство по эксплуатации

Страница: 12 / 16

12
6 MAINTENANCE AND SERVICE
To ensure a long-term quality from the cutting and a safe functioning of the machine without any problem, please follow the
maintenance plan below:
B
e
g
in
o
f
th
e
w
o
rk
D
u
ri
n
g
c
h
a
n
g
in
g
t
h
e
t
o
o
l
E
n
d
o
f
th
e
w
o
rk
E
v
e
ry
w
e
e
k
A
ft
e
r
a
b
re
a
k
d
o
w
n
A
ft
e
r
a
d
a
m
a
g
e
Whole machine
Visual control
general aspect, water tightness
Clean
Flange and blade fixing devices Clean
Motor cooling fans Clean
Water pump
Clean
Conveyor cart Clean
Water tray Clean
Water hoses and nozzles Clean
Water pump filter Clean
Conveyor cart guiding bars
Clean
Motor housing Clean
Reachable nuts and screws Tighten up
Maintenance of the machine
Always perform the maintenance of the machine with the machine isolated from the electrical supply.
Lubrication
The CLIPPER machine use life-lubricated bearings. Therefore, you don’t need to lubricate the machine at all.
Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work, especially water pump, water pan (which can be removed
for easy cleaning), motor and blade flange.
7 BREAKDOWN – CAUSES AND CURES
7.1 Breakdown-finding procedures
Should any breakdown occur during the use of the machine, turn it off, and isolate it from the electrical supply. Any works dealing with
the electrical system or supply of the machine can only be carried out by a qualified electrician.
7.2 Trouble-shooting guide
Trouble Possible source Resolution
Motor is not running
No electricity Check the electrical supply (fuse for example)
Connection cable section too small Change connection cable
Defective switch
CAUTION : can only be solved by qualified
electrician
Defective motor Change motor or contact motor manufacturer
Defective connection cable Change connection cable
Motor stops during the cutting, but can
be restarted after a short period
(overload protection)
Cutting advance too quick Cut slowly
Blade is blunt or glazed Sharpen the blade in calcareous stone
Defective blade Change blade
Wrong blade specification for the
application
Change blade
No water on the blade
Not enough water in the pan Refill the water tray
Water pump is switched off Switch the water pump on
Water tap is closed Open the water tap
Water supply system is blocked Clean water supply system
Water pump is not working
Prime the pump
Reactivate switch
CAUTION : if switch trips again, problem can
only be solved by a qualified electrician