Norton clipper CGW EVO D400, Руководство по эксплуатации

Страница: 12 / 20

12
3.5 Water cooling system
Fill the water pan with clean water to approximately 3cm from top (ensure that bottom of pump is
fully immersed in water). Use the pump switch on the side of the main switch to start the pump.
Open the water-tap on blade guard (note that handle on water-tap should be in line with water-flow).
Ensure that water is flowing freely in the circuit and is delivered adequately to both sides of the
blade, as insufficient water supply may result in premature failure of the diamond blade.
The water pump must never run without water. Always make sure that there is enough water in the
pan and refill if necessary.
In case of frost, empty the water cooling system from its water.
4
Transport and storing
4.1 Securing for transport
Before transporting the machine, always remove the blade and empty the water pan. Also remove
the conveyor cart, as it can be dangerous while you move the machine.
4.2 Transport procedure
Two people are necessary to move the machine. The machine can be moved with its feet folded.
Always fold the feet while transporting the machine in a van and a truck. The machine does not
have lifting hooks.
4.3 Long period of inactivity
If the machine is not going to be used for a long period, please take the following measures:

Completely clean the machine

Empty the water system

Take the water pump out of the slurry and clean it thoroughly.
The storage site must be clean, dry and at a constant temperature.