10
Figure 2-1: Removing the Rails.
Figure 2-2: Remove the Pan
• Do not try to remove the Dust/Water Collecting Pan without first removing the Rails.
• Removing the water pan without following the above assembly procedure will damage
Plastic Dust/water Collecting Pan.
Dust/Water Collection Pan
The Dust/Water Collection Pan is assembled to the machine from the factory. The following
procedure is to remove or to replace the Dust/water Collection Pan Assembly:
1. Remove Conveyor Cart (see page 11 Conveyor Cart Assembly for instructions) and then remove
the four (4) sets of Hardware (Bolt, Lock Washer, and Washer) from each corner of the machine
frame and remove the rails from the frame (see Figure 2-1: Removing the Rails). Note the
orientation of the Hardware and the Rails.
2. Remove the Dust/Water Pan Assembly from the frame (see Figure 2-2: Removing the Pan).
3. Replace the Dust/Water Pan Assembly if required.
4. Replace the Rails (note that the leg with the mounting holes will face towards the outside of
the frame.
5. Replace the Hardware. Snug the operator’s left hand side and fully tighten the operators right
hand side hardware.
6. Place the Conveyor Cart on the rails (see page 11 Conveyor Cart Assembly for instructions).
7. Align the Conveyor Cart to the blade by moving the operators left hand rail.
8. After the conveyor cart is aligned to the blade, tighten the left hand rail.
