Helpful Advice Before Fitting
Please retain all packaging until you have checked and counted all the parts and the
contents of the fixing pack against the parts list.
The fixing pack contains small items, which should be kept away from young children.
We suggest that you open the fixing pack and place all the contents into a container,
therefore reducing the risk of losing any small pieces.
Installation
The fire must not be used until it is securely fastened to the wall.
Do not connect the appliance to the mains until properly fixed to the wall and the
instructions are read fully.
The minimum distances must be observed in the diagrams above.
For installation of the appliance, care must be taken not to damage concealed cables.
Please be careful whilst drilling holes.
This appliance is designed to be permanently fixed to a wall at a minimum height of
300mm.The wall bracket must be fitted horizontally and the cable routed to the bottom right
of the heater.
A distance of 600mm from bottom of heater to floor is recommended for optimum viewing of
fuel bed; see
Fig.1
for recommend fixing dimensions.
For optimum viewing, mark the top four screws fixing positions on wall in accordance with
the recommend fixing dimensions- see
Fig.2
.
NOTE:
ensure that the bracket is level by using a Spirit level whilst marking out the hole
positions.
Drill holes with a No. six drill bit.
Fix the wall bracket using that the plug and screws provided.
Attach the lower fixing bracket the base of the fire using the two small black screws
supplied; ensure the bracket is fitted so that it is level with the back.
Carefully lift the heater up ensuring that the top rear ledge of heater engages with the wall
bracket (see
Fig.2
in circle) and is sitting centrally. This process should be carried out by
two people to avoid injury or damage to property or the appliance.
Gently bring the heater down against the wall.
Mark the lower fixing bracket two fixing hole positions on the wall-see
Fig.3,
remove the
heater.
Drill the wall and insert the wall plugs.
Refit the heater to the wall and fasten the bottom fixing bracket to the wall using the screws
provided to permanently fix the heater in place.
Place the front surround over the front of the fire aligning the slots in the brackets at each
side of the front panel with the lugs on the sides of the fire-see
Fig.4
.
Again two people will be required for this operation.
Instructions for Use
The appliance can be operated either by the switches located on the top right hand side of
the fire or by the supplied remote control.
Содержание EF455S
Страница 2: ......
